This page sets the datasheet figures of two sports perimeter boards side by side, with weight and draw per square metre worked out where a sheet prints them per cabinet or the other way round.
| AOTO SP10V-1600X1200 | Dicolor F2-100 | |
|---|---|---|
| Manufacturer | AOTO, SP series | Dicolor, F2 series |
| Pixel pitch | 10 mm | 10 mm |
| Cabinet size | 1600 × 1200 × 120 mm | 1280 × 960 × 100 mm |
| Pixels per cabinet | 160 × 120 (19,200 px) | not published |
| Weight | 65 kg (34 kg/m², derived) | 45 kg (37 kg/m², derived) |
| Maximum power | 1,300 W per cabinet (677 W/m², derived) | not published |
| Typical power | 382 W per cabinet (199 W/m², derived) | 258 W/m² (317 W per cabinet, derived) |
| Brightness | 6,000 nits | 8,000 nits |
| Refresh rate | 18,000 Hz | 3,840 Hz |
| Viewing angle (H / V) | 160° / 100° | not published |
| Ingress protection | IP65 | IP65 front, IP54 back |
| Stand tilt | not published | 70° to 90°, in 5° steps |
By weight per square metre, the AOTO SP10V-1600X1200 is the lighter board: 34 kg/m² against 37 kg/m² for the Dicolor F2-100, which is what the ballast and the stands carry along a run.
On typical content the AOTO SP10V-1600X1200 draws less: 199 W/m² against 258 W/m² for the Dicolor F2-100.
Circuits are sized on maximum draw, and the sheet for the Dicolor F2-100 does not publish it, so a power plan for a run needs that figure from the maker.
The Dicolor F2-100 is rated brighter, 8,000 nits against 6,000 nits.
Perimeter planning is not in the RigPlan planner yet. The planner works in one rectangle of panels, flown, stacked or wall-mounted; a perimeter run is segments of one row in a line round a field, on stands with ballast, with fibre between segments. These pages are for looking boards up and comparing them. Every board in the database is on the perimeter boards list.